Your ultimate defence against corrosion. Follow our expert guidelines to ensure long-lasting protection for every surface.

Aluminium

Surface Preparation Guide
Good surface preparation is essential for successful coating adhesion. The following procedures must be followed:
  1. Degrease surface using Transomarine Thinners and clean rags.
  2. Disc abrade or hand sand with a fine grade paper to achieve an all over dull finish.
  3. Pretreat with Transomarine Acid Etch.
  4. Thoroughly wash and scrub using fresh water.
  5. Apply Alodine passivator in sections allowing four minutes minimum, reaction time. Before using a product of this kind, ensure you thoroughly read the manufacturers Health & Safety information & production instructions.
  6. Ensure surface is dry, then apply coating system.

Base System

2 coats 113 Zinc Chromate Primer
2 coats 199 Epoxy Primer Undercoat

01.13 Zinc Chromate Primer 3:1

$95.92

01.99 Epoxy Primer Undercoat 3:1

$76.92$257.34

Below Waterline

2 coats of selected Antifouling

Deck and Cockpit

2 coats 343 Polyurethane Gloss or 331 Gloss Enamel

Cabin and Topsides

2 coats 343 Polyurethane Gloss or 331 Gloss Enamel

Cabin Interior

2 coats 343 Polyurethane Gloss or 331 Gloss Enamel

Deck Wall Areas

2 coats 460 Epoxy Finish or 343 Polyurethane Gloss
Non skid may be provided by using Protective Paints 01.000 Non-Skid Additive to those areas requiring this finish.