0800 paint it

Your ultimate defence against corrosion. Follow our expert guidelines to ensure long-lasting protection for every surface.

Ports and Marinas

Surface Preparation: Ensure surfaces are degreased and free of contamination using Protective Paints A925 – Metal degreaser (follow instructions as per data sheet). Ensure all Corroless data sheet preparation procedures are strictly followed. Ensure surfaces are free from preparation debris and are clean and dry. Apply 1st coat within 4 hours of abrasive blasting. Practical coverage is project dependent. All data sheets can be found at the back of this manual.
  • DFT = Dry Film Thickness
  • WFT = Wet Film thickness
  • TDF = Total Dry Film thickness
Below waterline exterior

Steel submerged in Ports and Marinas (Buoys and pontoons)
Abrasive Blasting Sa 2½ of AS 1627.4 (Two pack system)

1st and 2nd coat

Apply Corroless EPF at 210 µ WFT( 200 µ DFT)

3rd coat and 4th coat

Appropriate antifouling

TDF = 350 microns minimum
Above Water Exterior

Steel exposed in Ports and Marinas Abrasive Blasting Sa 2½ of AS 1627.4 (Two pack system)

1 st coat

Apply Corroless EPF at 210 µ WFT( 200 µ DFT)

2nd and 3rd coat

Apply Corroless RF 60 at 50 µ WFT ( 30 DFT) tinted to
approved colour

TDF = 260 microns minimum
Equipment and Structural steel

Container cranes, equipment and beams
Abrasive Blasting Sa 2½ of AS 1627.4 (Two pack system)

1st Coat

Apply Corroless E at 80 µ WFT( 50 µ DFT)

2nd and 3rd coat

Apply Corroless RF 60 at 50 µ WFT ( 30 DFT) tinted to
approved colour

TDF = 110 microns minimum
Specification subject to NZS/AS 1627; Preparation of surfaces NZS/AS 2312 Protection of mild steel; AS 3894 Determination of Dry Film thickness